Bump stops either side of the boot lid - sourcing?

[HPsauce]

I've been pondering how to get the metal insert to work on a 3d printer but I think I do have a solution to that.

The rubberised coating isn't really that thick on the side that contacts the bodywork, only a mm if that. You could probably just print a shell that fitted over the metal insert and a separate thin sheet with suitable hole for the body side and glue the 3 parts together?

Take measurements of the outside then strip all the rubber off, measure the metal and reuse it as the core?

[The_Laird]

Has anyone found a supplier for the lower, adjustable, stops without paying silly money?

[HPsauce]

I think the same guy in Germany does them, or parts of them. https://www.ebay.co.uk/itm/126314927892