So, since the cold snap the barge hasn't been starting. I put it down to the battery, which was defo goosed, but now it has a fresh one it's just turning and giving the occasional splutter. It was giving a P1602 code this morning. I'm imagining that was from the low power of the previous battery? I reset and tried turning again. It didn't re-throw the code or any other codes at all. Still didn't start though
Not sure where to start tbh. I've disconnected the battery for a bit, but I doubt that will help as I don't think the ECU's on D2's need coded/reset after battery swaps, do they?
Any suggestions of likely candidates appreciated, before the goose chase commences
