Gearbox toast
Re: Gearbox toast
Lmfao 
Ive not read his feedback. I was supposed to go see it as it's about 50 mins away but not managed to get time. Might just go now.
S8 FE Black/red
S8 FE Blue/Morning Dew
S8 FL Grey/Black
Touareg 5.0 V10 X2
Phaeton 3.2 V6
S8 FE Blue/Morning Dew
S8 FL Grey/Black
Touareg 5.0 V10 X2
Phaeton 3.2 V6
- Spannerrash
- Posts: 30
- Joined: Thu Feb 27, 2025 7:51 pm
Re: Gearbox toast
Mine is still stood on the drive waiting for me to decide what to do about it's gearbox problem. It's a really tough call. Nice car, gets lots of attention from delivery drivers etc even parked up. I feel like I would like to be driving it but at £6k repair it just makes no sense. Plus the other stuff that will need doing over the next couple of years. Tyres, timing belt, power steering pipes probably, oil cooler is leaking water again. I fixed this 8 years ago but I guess I either did a crap job or they only last 8 years.
I do have a "clutching at straws" moment going on just now though. I believe the possibility of a hairline crack in the 1058 427 068 valve body can give the same symptoms that my gearbox is displaying. I always intended to drop the oil pan anyway to inspect for shrapnel to aid my decision process so I think I'll drop the valve body at the same time to see if I can see anything. I'll be doing it this spring so I'll keep you posted.
I do have a "clutching at straws" moment going on just now though. I believe the possibility of a hairline crack in the 1058 427 068 valve body can give the same symptoms that my gearbox is displaying. I always intended to drop the oil pan anyway to inspect for shrapnel to aid my decision process so I think I'll drop the valve body at the same time to see if I can see anything. I'll be doing it this spring so I'll keep you posted.
- Spannerrash
- Posts: 30
- Joined: Thu Feb 27, 2025 7:51 pm
Re: Gearbox toast
This is what it may look like. Easy enough to replace so fingers crossed.
You do not have the required permissions to view the files attached to this post.
-
MikkiJayne
- Posts: 181
- Joined: Wed Sep 06, 2023 6:26 pm
Re: Gearbox toast
Interesting, I've never seen that happen before.
- Spannerrash
- Posts: 30
- Joined: Thu Feb 27, 2025 7:51 pm
Re: Gearbox toast
It's no longer available but luckily I have a good used one. Apparently it's such a common issue that Ericsson offer a repair service on an exchange basis.
I really am clutching at straws her but if it's not this then the gearbox will have to come out. At 60 years old and spending over 40 years as a maintenance engineer I'm not sure my back and knees are going to thank me for it.
It will be a shame if it's the A Clutch drum or Orings / thrust bearings as I think it's quite a straightforward job, once you get the gearbox out. That's gonna be the tough part.
I really am clutching at straws her but if it's not this then the gearbox will have to come out. At 60 years old and spending over 40 years as a maintenance engineer I'm not sure my back and knees are going to thank me for it.
It will be a shame if it's the A Clutch drum or Orings / thrust bearings as I think it's quite a straightforward job, once you get the gearbox out. That's gonna be the tough part.
-
MikkiJayne
- Posts: 181
- Joined: Wed Sep 06, 2023 6:26 pm
Re: Gearbox toast
Take the engine and gearbox out together on the subframe if you have to. Its far easier like that than trying to get the gearbox out on axle stands. Buy/borrow a pallet truck and you can lower the subframe on to it and then wheel the whole assembly out.
Take the engine off the gearbox using an engine crane with levelling bar, not the other way round, as the engine's CoG is more predictable than the gearbox.
Take the engine off the gearbox using an engine crane with levelling bar, not the other way round, as the engine's CoG is more predictable than the gearbox.
